Discussion Locked

Windows 2k runs 5 minutes then freezes

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recentlty installed windows 2000pro on a amd 500 computer. The motherboard is an fic 503a motherboard with pc133 memory. I have 384 meg worth. The video card is an ATI Radeon DDR 64meg VIVO card. Win2k runs for about 5 minutes and then locks up. Sometimes it the screen goes black and is frozen. Is my memory bad or the video drivers? My hard drive is a 20 gig maxtor UDMA 66. The memory was recently purchased.

11 replies

by campbell

First I would boot into safe mode(vga mode) and see if the computer locks up. If it does not, then it sounds like a driver problem. If it does lock up try removing some RAM and see if it still locks up. It may also be an processer over heating issue, open the case and see if you fans are working. Does the vid card have a fan? is it working?
Hope this helps

by tbradley

Chances are, if it runs for 5 minutes, then locks, the problem is the load Win2k places on the processor.

Running on historical facts, Packard Bell computers ( 486dx33 ) versions ran flawlessly for years with win3.1 They experienced the same problem you describe when Windows 95 was loaded.

The problem, after some reluctance by PB, was admitted to be heat caused by higher CPU usage.

There would only be one way to check, and that would be to load 95/98, and see how the beast reacts.Let it run an active screensave for 24 hours. Load Win2k, run the same Screensave, and see how long it lasts.

Other than replacing the Motherboard and CPU, everything else would be a bandaid solution.

by michelm

I had a similar problem with my system in the past. It was caused by the power consumption of the AGP graphic adapter.

I identified the problem by reducing the AGP speed to 1x (I used the tool powerstrip see www.entechtaiwan.com)

Of course it might be an driver issue or another hardware problem, but maybe you give this little tool a try.

Michel

by jpo

I've had freeze problems since W2k was first released. My methods: Read event logs First!

1) In safe mode (F8), device manager, disable any drivers with an exclamation mark, one at a time until stable, then go to microsoft.com/hcl to check compatability. Update drivers from manufacturer's site, or purchase a new compliant device.
2) If all are disabled and freeze continues, uninstall all device drivers (no hidden system drivers). Physically remove all devices and reinstall the drives/cards one at a time, reinstalling updated drivers each time. This requires having downloaded drivers in advance on a disc that is read by the first device (drive), you reinstall.
I've found that simply removing and reinstalling cards (especially modems and display cards) without messing with driver updates at all will actually improve stability.
Good luck

by gd96

First and formost, what kind of power supply do you have, AMD chip and their motherboard counterparts are notorius for needing a powersupply that has at least a rating of 250w ,continuous power, and the FIC Boards in particular are very fussy when it comes to power consumption. Remeber that todays video card draw a lot of power , especially something like the ati radeon 64 meg..If that deosn't solve your problems then you should install the newest bios for your MB and get the latest drivers...

This discussion is closed to new replies.