Windows Forum

Ask something
Discussion Locked

Windows keeps Hanging

0 helpful
7 replies

by clarkkent

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

were using Win me and when i close and windows and rebot the systems it opens only safe mode after the safe mode then the black screen will appear and the blink cursor appearing on the top.

Again i reboot the system so many time and same thing happen after, this error message appears (error 060167 bff44008)? any idea what is this caused of error

7 replies

by lizzy

Let the PC boot into Safe Mode and go to Start>>Settings>>Control Panel. Double click on the System applet and go to the 2nd tab for devices. Check the resources of different devices for some sort of conflict (2 devices trying to use the same memoryaddress--bff44008 is a memory address). See if any devices are not installed properly with an X or yellow exclamation. Conflicts or problems found--Remove the device, have the drivers ready, reboot and try to reinstall. After reinstalling, reboot again and check the devices for conflicts or problems. Good luck.

by jlouis45

I feel the problem is due to the wrong instation. But still try these.
1. Well fistly you have to know that WIN ME requires some minimum hardware requirments. 2. Secondly if you have the required H/W you boot with a clean floppy and check if you have installed any unwanted programs recently.
3.If all is well then try reinstalling the WIN-ME again. May be you havent installed the win me properly.

by mlusk

I have found that the blinking cursor at the top right normally means video driver issues. Try removing the video drivers in safe mode and then reboot. You can then re-install your drivers.

This discussion is closed to new replies.