Question Locked

Windows XP banner screen appears and turns into black screen, bad vid card

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Im working on a Gateway machine about 6 yrs old and when I turn on the machine appears to boot normally however after the Windows XP banner screen it acts like its going to load and then nothing but a black screen occurs. Can't go into advanced settings or BIOS..Any suggestions would be helpful. I think it is the video card..

5 replies

by oh smeg

To enter BIOS you need to push the Delete. F2 or F10 key when the Gateway Logo is on the Screen. If you attempt to do anything after this stage you only have either the option of Entering Advanced Settings or allowing the system to Boot Normally.

To enter the Advanced Start Mode you press the [b]F8 Key[/b] while the Gateway Logo is on the screen and hold it down till either the internal Speaker starts sounding or the Monitor turns to a White on Black Screen. In both cases once you see the XP Logo and Blue Moving Bar it's too late to do anything other than allow the system to start normally or at the very least attempt to.

Try Selecting the Advanced Mode and using the Arrow Keys Navigate to [b]Safe Mode[/b] and then press the Enter Key. Follow the Prompts and as the XP Splash Screen isn't shown now you will see what is actually being loaded. If the screen still goes black pay attention tot he last thing being loaded and make a not of it. If it works and goes to Safe Mode delete the Video Drivers and then allow the system to restart and find new Hardware. Allow the unit to load the Default Drivers or older ones that actually worked and the system should now be OK if there isn't a Hardware Issue involved here.

Col

by j.candelaria

I have tried to press F8,F10 and F2 before the Windows XP screen appears but nothing..I was trying with a wireless keyboard and mouse if that makes a difference. I did get a message once stating Windows did not start correctly and I went into safe mode however it went to a black screen after.

by larryd4

Try booting in to safe mode and dropping your screen res to like 800 x 600. Then boot up normally.

This discussion is closed to new replies.