General discussion

Locked

winipcfg

By brian_mccain ·
What is the command line winipcfg for Win 95/98 in Dutch, French and German. I need to release and renew my IP address for the Nic card. I also nedd to know the translation for ipconfig /release_all

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

winipcfg

by Stillatit In reply to winipcfg

Try typing the command followed by /?
ipconfig /?
This will give you the explanation and examples. There are only three choices, so it should be easy to figure out.

Good luck.

Collapse -

winipcfg

by brian_mccain In reply to winipcfg

The question was auto-closed by TechRepublic

Collapse -

winipcfg

by KEITHpup In reply to winipcfg

all windows 9x use winipcfg not ipconfig. Ipconfig is for the nt krnl only. When you go to the start run and type in "winipcfg" and press "ok" you get a graphic representation of the IP config of the PC. Just hit the release and then reboot and and windows 95 will (if the IP settings allow it look to DHCP to give a new IP or hit release all and then renew all.

Collapse -

winipcfg

by brian_mccain In reply to winipcfg

The question was auto-closed by TechRepublic

Collapse -

winipcfg

by brian_mccain In reply to winipcfg

This question was auto closed due to inactivity

Back to Windows Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums