Question Locked

XP Not Showing my slave drive in Device Manager or Disk Management

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just added a WD Caviar 80G HD as a slave to a WD Caviar 40G. BIOS shows it installed as a slave drive but XP doesn't even reflect that it exists in device manager OR disk management. I even tried DISKPART and RESCAN, etc., but NOTHING. I've checked just about everything! Jumpers, cables, etc. and it's all set up right. The only thing I can think of is that the 80G is an older 5200rpm model and my master is a newer 7200 but would that affect it? Any help would be GREATLY appreciated.

4 replies

by Former member

For Windows to see your drive you have to format it. Solution: Reboot your computer in to the bios (DEL, F1, F2 keys for bios, Depending on your system)and select your WD drive in the "boot" section of your bios once done then "Exit and save" this will reboot your computer on the new hdd, insert Winxp, 98. or what other Windows Os you have, when all done and it boots fine then go into the bios again and change back to your master hdd, and "exit and save". Hope this works for you.

by jlips50

I had a similar problem when adding a drive.
I had reloaded xp pro and when finished I had just the single drive. Later on after taking all updates and upgrades to sp2 lo and behold there was my second drive Yeah!

by maccman23

I've had a similar but bizarre experience. My xp home
system 'lost my WDC 2500JB Slave drive. i run a maxtor
ide 160gb master plus a 250gb sata drive. i have tried
checking all the cables etc and no luck. Then.....
i decided to unplug the master and the sata and tried the
slave on its own. it let me install xp and works perfectly,
yet when i tried to put everything back the way it was,
same again, the other two drives work fine yet the wdc
appears in the bios( it even auto detects it) but it doesn't
show in device manager or computer managemnet.
it would be easy enough to run it as a slave drive but i
don't fancy reinstalling all my progs on it just in case
there is a deeper problem.
i went back to the config where the slave became the
master and an am running a scandisk as we speak but if
this doen't work i'm stumped.
if it works as a master surely that signifies all the cables
are ok( the sata and the original master work ok in this
config) but doesn't work in my original config.
anyone seen this before?
Thanks
Dave

This discussion is closed to new replies.