Discussion Locked

XP PRO install does not reboot into setu

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I oridinally had xp pro on my machine. I wiped my drives due to an error with my dual boot. I am trying to install windows XP PRO from a blank hard drive. Everything goes fine up untill till tells me It needs to reboot. The computer reboots and I get an error CD101... Then after that no operating system found.

12 replies

by mikesavasta

Error Message that comes up after Reboot
Couldn't open drive multi(0)disk(0)rdisk(0)partition(1)

NTLDR:Couldn't open drive multi(0)disk(0)rdisk(0)partition(1)

by quintar51

I recommend to boot off the cd, or floppy disks, blow away all partitions, and install from scratch, to see if the error is consistent.

by quake_sinatra

what was your dual boot? what was the other OS.. linux? Lilo still on your MBR?
are you running on an ultra ata card? straight of the motherboard?

by wcp

This is most likely a RAM issue.

For each action or step you take, you need to install Windows from scratch. If you do not see the error any more, you are done. If you see the error again, you go to the next step.

1). Make sure your hard driveis error free (i.e. no bad sectors or clusters) and blank.

2). Reseat RAM(s) firmly.

3). If you have only one RAM, replace it with a known good RAM.

4). If you have more than one RAM, you need to isolate which one (or more) is bad. The easiest procedure is to take all of them out and put one at a time until the error is gone.

5). If you still have the error, you need to test CPU and M/B. Unless you have any spare known good replacement, you better take your computer to a dependabletechnician for troubleshoot.

This discussion is closed to new replies.