Question Locked

XP will not load, neither will anything else!!

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I posted earlier today and a very helpful person from
Australia helped.
My son downloaded a virus and destoyed the system.
Briefly, I have now acquired a Kill Disk CD and run it,
thereby cleaning the whole HD.
Guess what?
I ran XP pro set up and it STILL stops at the point where it
should load up windows?
Why is it doing this. The HD is now completely clean!
I have been at it since last night and I have run out of
ideas, so please help guys.

Regards

Chris

8 replies

by bart777

You will want to get a disk diagnostic program from the computer manufacturer (Dell or HP if that's what it is) or from the HD maker.

Run that program against the disk and hopefully it will find and correct any problems.

If this is a Dell you can press CTRL-ALT-D before the windows scren would normally start and it will run it's own internal diag program. I think HP also has one but I don't recall the key commands.

Best of luck

by rob miners

you try what I suggested in your previous post. You will have to at least put a Partition on the drive.

by christopher.arnfield

I`m sorry but I have been up for nearly 36
hours trying to sort this out, and I am
going to bed after this post.
I am unable to access anything other than
with Knoppix. If I partition the drive with
that, windows wont recognize it anyway.
Nothing seems to work. I have been told to
use the DOS prompt, but whenever I enetr
fdisk or format it just says `bad command`.
I have ud=sed active kill disk to
completely over rite the HD so it should be
like a blank canvas, so why is the OS disc
stopping where it starts to upload windows?
I tried an Ububtu disk, and that also stops
at the beginning of the set up?
Is it possible that the motherboard has
been destroyed by the virus?

Regards

Chris

by w2ktechman

of a bad hard drive for this. Or maybe it has a loose connection to the MB. Check the cabling, and replace cables to see if that is the issue.

by rob miners

You can use the Hard Drive Makers Testing Utility to Test the Drive

Hitachi / IBM - DFT "Drive Fitness Test"
http://www.hgst.com/hdd/support/download.htm
Works with all manufacturers

Western Digital "Data Lifeguard"
http://support.wdc.com/download/index.asp#dlgtools
Works with WD drives only

Fujitsu "FJDT"
http://www.fel.fujitsu.com/home/drivers.asp?L=en&CID=1
Works with fujitsu models only

Samsung "hutil"
http://www.samsung.com/Products/Hard...ties/hutil.htm
Compatability unknown...

Seagate "Seatools"
http://www.seagate.com/support/seatools
Works with Seagate drives only

by the scummy one

the original, so if this was previously mentioned, sorry for the duplicate

Are you using a SATA drive? If so, this may be the problem, you will need to download and install the drivers.

by christopher.arnfield

Thanks to all that replied.
It is now October 2009, and I have just got around to sorting out my old PC.
It turns out that the problem was the three Capacitors on the motherboard. I have since found that this problem is well documented, so I will not bore you with it here.
Suffice to say that anyone with a motherboard with GSC capacitors on it need to have a look at them. Check out this article:-
http://www.pcstats.com/articleview.cfm?articleID=195

Hope that this helps anyone who has the same problems I had.

This discussion is closed to new replies.