Question Locked

XPPro won't completely boot up on HP OmniBook XE3-GC

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've been stumped by the HP Omnibook XE3GC as I've tried to upgrade from working 98SE to the more modern era of XP. P3 700MHZ; 192mb Ram; 10GB HD. Does anyone have a solution or suggestion (last ditch effort will be to revert back to 98SE if all else fails)?

Larry

4 replies

by oh smeg

http://tinyurl.com/6xsr3m

It's from HP's Latest updates for this device and says

[i]Known issues using Windows XP
Manual H/W Detect Scanning through Device Manager
Windows XP offers multiple methods for the user to add / detect new hardware. It is not anticipated that the
user would ever need to perform a manual hardware scan since most new devices support plug and play or
come with install CD?s. However, if there is a need to perform a hardware scan, the use of the ?Add
Hardware Wizard? through the Windows Control Panel or Windows System Properties is recommended.
Use of the Device Manager to manually scan for new hardware is not fully supported at the present time and
therefore not recommended.[/i]

So I'm assuming that HP doesn't have a full complement of Drivers for this unit even if it is XP Compliant.

Col

by Former member

XP needs to run:
1). 512 mb of ram
2). a bigger hdd of around 20gb or more.
3). Windows is memory hungry, so more memory the better. If you can NOT update your memory then the best bet is to keep to Win98 SE.

Please post back if you have any more problems or questions.

This discussion is closed to new replies.