Discussion Locked

install scsi adapter

0 helpful

7 replies

by trinhpham54 May 11, 2001 last reply May 14, 2001

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

after installing the scsi adapter,the system is not able to boot up, got blue screen error

7 replies

by estebandelatorre May 11, 2001

THE SCSI DRIVER IS INCORRECT.
BOOT PRESSING THE SPACE BAR IN ORDER TO BOOT WITH THE LAST KNOW GOOD CONFIGURATION.
IF NOT ABLE, BOOT FROM THE 3.5" FLOPPY NT START UP DISK AND ISSUE A REPAIR NT INSTALATION.
ALSO THE BOOT INI FILE COULD BE CHANGED AND IS ATTEMPTING TO BOOT FROM SCSI DRIVE WHILE IT SHOULD BE FORM IDE.
REMEBER A GOOD ISSUE: ALWAYS HAVE AN ERD DISK BEFORE LOADING, SPECIALLY, NEW DRIVERS!

by trinhpham54 May 14, 2001

Poster rated this answer

by noodle May 11, 2001

I'd check you adapters docs for irq/plugnplay
default settings. then make sure within systems bios you have that irq available or plugnplay assigned the irq. Just some ideas
hope this helps