Discussion Locked

Installation of Large HDD 20gig

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

You asked: How do I install a 20 gig HDD on a Toshiba 8000D, The BIOS setting shows HDD set on secondary hdd setting and I can not ssem to find the right cable select or BIOS setting to see the HDD, what shoud I do?

7 replies

by glenna

Did you run fdisk /status?
What did it show?

Did you try moving the jumper on the drive to Slave?

Did you try installing the drive a Primary on the second IDE controller?

by mski

If the above suggestions fail, it may be that your motherboard does not support this new drive you have. Download a bios update for your system board and flash the bios as per the manufacturers instructions (follow them carefully, improper flashingmay make your motherboard unusable).

by thechas

First, BIOS must recognize the drive before you can do anything.

If the new drive is connected as the slave, make sure that the jumpers on both drives are set correctly.
Many drives require different jumper settings when used with a slave as oppossed to used as a single drive.

I have also seen HDDs of different brands not be compatible with each other on the same IDE channel.

Another possability is that your BIOS cannot recognise the new drive at all.

Check with Toshiba for an update.

If not, your next best option is a PCI bus IDE controller card.
These have there own BIOS for the drives, and speed up HDD data transfer on older PCs.
You can find the cards for under $30 at numerous web-tailers.

Chas

This discussion is closed to new replies.