Discussion Locked

mouse this is for thechas Charlie Harag

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Charlie you answered my first question and I made a mastake and did not award you your points I am sorry and will correct that problem just answer this question THIS IS FOR THE CHASE ONLY PLEASE.

The mouse had been unplugged and plugged back in with the power on is there any way to
repair the PS/2 port short of replaceing the motherboard or can I work around this port?

3 replies

by thechas

Thanks for thinking about me.

As far as 'repairing' the motherboard, it usually is less expensive to just replace the board.
Between the 'retail' cost of parts, and the cost of equipment to properly de-solder and re-solder the parts onto the motherboard, the cost of repair could easily exceed $100.

There are 2 possible work-arounds:

Use a serial mouse.

Use a USB mouse

For the USB mouse, you need Windows 95 "C" or later. (Not NT)

For the serial mouse, you may just need an adapter.
NOTE: Not all new mice have serial port support. Make sure that you get a TRUE serial mouse.

You may need to enable the serial port in BIOS settings, as many PCs now come with the serial ports disabled to free IRQ's for other devices.

Youcan give a new PS/2 mouse a try, just in case the port is ok, and the electronics in the mouse was damaged.

Good Luck,
Chas

by nikki2000

your answer was verry helpfull ....i bough a new mouse fellowes mouse that i could use eather way ...and it just happened to be my old mouse that was bad the new one worked just fine oluged in to the ps/2 conection on my motherboard..
thanks chase

This discussion is closed to new replies.