Discussion Locked

Adaptec 2940 bios installs twice on boot

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My 2940W bios installs twice upon boot. This causes my single Seagate Hawk 4.55gb (ST34555W) to be installed twice as C: and D: drives. The drive has been fdisk'ed and formatted as a single volume. All terminations are correct.

11 replies

by nsceml

Yes, both C: and D: report as the full 4.55gb when only one drive is actually installed.

by md_hashim

Seems like you have a problem at the chip level. Suggest you check with the vendor whom you got the system from.

by nsceml

Thanks for the reply, but it is to general to be of much help and I am the vendor, it's a homegrown box.

by s_pryce

When the system boots the AHA2940 BIOS will announce itself - press ctrl-A to enter the bios and go to scsi utils. A list of 16 addresses will come up with the AHA2940 on 7 and the Hawk on 0 if the hawk is on all address up 6 or 7-15, then the hawk is on radial select, get the jumper settings from seagate and disable it.
If the hawk is on just 0, go back to options and then bios options and disable support for int13 extensions.
If already disabled, reply back with what the rest are set for on that page and what OS your running.
Hope it helps !

by nsceml

Good answer and I can tell you are a man "as one with scsi", but I have tried all these settings already and none of it worked. But thanks!

by nsceml

Question #2 S_Pryce@ hotmail.com

int13 was enabled but changing that didn't do anything. Tne drive is jumpered for ID 0. Card is ID 7.

Under scsi device config, down the line under ID-0 is yes,40.0,yes,yes

Under adv config
PNP scam----------dis
host adapt. bios--en
support removable-boot only
ext trans >1gb----en
multi lun---------dis
bootable cdrom----en
int 13------------dis
support for ultra-en

I have played wth all these settings to no avail.

by nsceml

Would like to run W98, but all this takes place before any OS loads. Thanks for the help, surely someone has seen this before.

by nsceml

OK! I really need to get this going or go back to an IDE HDD. If anyone can help me with a correct answer before I figure it out myself or I burn my scsi card (which ever comes first) I will add an additional 400 tech points to make it a 1000 point total. I have plenty of tech points and this is the first question I have posted so be assured I wll give you the points. Hey "soulrider" or "pmwright", one of you guys are sure to know the answer. I don't have a TSID so adaptec won't help. If someone would like to use there TSID to ask adaptec tech support what the deal is and forward me that email, surely that would be worth something. Thanks to all who reply.

by nsceml

I have it figured out. The 400 extra points are no longer available but I would still like to know what adaptec's response is, so if someone would like to use there TSID to ask adaptec tech support their opinon and forward me that email, I will award that person the 600 available points.

This discussion is closed to new replies.