General discussion

Locked

"ADF Empty" Scanpartner Error

By glenn.hunter ·
I am trying to install a Fujitsu Scanpartner 15c on a Windows 2000 machine. After going through the setups again I am still getting "ADF Empty" error if I try to scan from the Flatbed instead of the ADF. If you have seen this Please contact me.

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

"ADF Empty" Scanpartner Error

by kimsi84 In reply to "ADF Empty" Scanpartner ...

I would check the cabling from the ADF to the scanner. Also, you may want to make sure that the paper sensor flag is in place in regard to the ADF.

Collapse -

"ADF Empty" Scanpartner Error

by glenn.hunter In reply to "ADF Empty" Scanpartner ...

If it scans when paper is in the ADF. Cabling could not be the problem nor paper sensor because it knows when paper is present or not.

Collapse -

"ADF Empty" Scanpartner Error

by chris_mcgraw In reply to "ADF Empty" Scanpartner ...

Glenn try going into Select Source select the Fujitsu Limited TWAIN Driver not the Fujitsu STI ScanPartner 15c. That should give you the option to select from ADF or Flat Bed.

Collapse -

"ADF Empty" Scanpartner Error

by glenn.hunter In reply to "ADF Empty" Scanpartner ...

Poster rated this answer

Collapse -

"ADF Empty" Scanpartner Error

by glenn.hunter In reply to "ADF Empty" Scanpartner ...

This question was closed by the author

Back to Desktop Forum
5 total posts (Page 1 of 1)  

Related Forums