Discussion Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Just bought the MB and CPU combination above. It came pre-configured with fan from the company. Installed in case with 200W power supply and it would not fully power up and would just shut down. Looked at the documentation, which said it needed at least 230W, preferrably 300W PS. I bought a case with 300W PS and installed the MB/Chip and all other necessary hardware. I checked the power up process after plugging in each board and hooking up each drive. Everything was fine. Even installedWindows XP Home Edition with no problems and set up several users. It had been powered down and up several times during the install process. Turned off the machine and moved it to another room in my house so I could get to an internet connection.It then started with the same problem as before. Turn on the power, the Chip fan comes on briefly, then everything powers down. Anyone have any suggestions? Thanks in advance for the help.
4 replies
by jlouis45
i guess u have not configed the mother board settings for the CPU fan settings etc. There are switches on the motherboard to be set when you use a specific process eg.2.4 Ghz u need to set it. Check the motherboard settings, fan settings etc. And once again check the connections. PIV has a new system wherein you need to plug an additional 4 pin wire which is square. fix them.
All the jumpers and setting on the MB were set correctly and verified twice. I have since found out that this behavior (powering up partially and then powering down) only happens when the machine is physically unplugged and then plugged back in. Once it is turned off and then back on, the machine boots. I have also checked system temp, cpu temp and fan rotation speed which are all within norm. Since it works any other time, I have stopped trying to figure out what is wrong. Thank you for your efforts and advice.
by wcp
Boot the computer with the minimum hardware (HW) requirement.
This means to disconnect all HW except Power supply, Motherboard (M/B), CPU, CPU fan, RAM, and Video card.
Does the computer power down as before?
If it does, one or more of above HWis causing the problem. Unless you have a known good replacement to test each of the above, you better take the computer to a dependable technician to troubleshoot.
If the power-down stopped, then one or more HW you disconnected is causing the problem. Add one component at a time (e.g. FD, HD, CD-ROM, NIC, and so on) to find out which one is the bad guy.
I had done exactly that as I was rebuilding the machine. As I plugged in each card or connected the power supply to something else, I made sure the machine was booting up as far as possible. I had worked on it for at least 4 hours after completingthe build and it worked fine. I have since found out that this behavior (powering up partially and then powering down) only happens when the machine is physically unplugged and then plugged back in. Once it is turned off and then back on, the machine boots. I also checked the system temp, cpu temp and fan rotation speed which are all within norm. Since it works any other time, I have stopped trying to figure out what is wrong. Thank you for your efforts and advice.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies