General discussion

Locked

automatic back up for ethernet WAN

By v.prakash ·
Hi all,

I have two WANs, which are both ethernet based interface connected to my cisco router. I need to use one ethernet WAN as the main link, and the other as automatic fall back. As it is an ethernet interface, it is not going to go down, even when the physical layer(WAN) is down. Can any one help out with a configuration that would automatically switch to the back up ethernet line, in case the primary link goes down.

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by joe_kim_mikey In reply to automatic back up for et ...

Hello... I my self use ACRONIS TRUE IMAGE CORP. Edition??? Its a little bit spindy BUT... When you install use the work station It will take a picture of your entire network... and back it up on a disk??? Any problems just tell ACRONIS to go back FIXED... Joe

Back to Networks Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums