13 replies
by alpha-male
While it's certainly possible, I'd be much more likely to suspect a power source/power supply problem. Take a look at that first, and, if the power related issues are all fine, then I'd look at the video card (particularly if the monitors were new).
Good luck!
by swomack
by satyre
by swomack
by labazzo
by swomack
Hi most modern monitors are controlled by microcontrollers and any signal that is outside of its operating range just causes the monitor to free run and if it has time to display an error message of some sort. Having said this it is unwise to run your monitor at full tilt just because it can run at 1600x1200 at 100Hz may not be in the interests of longevity.
Would you drive your car with your foot to the floor all the time assuming the law would allow.
Rich
by swomack
by rcom
What type of monitor? What happened to the monitors? Did they just go blank, popping and burning smell whatever? How long a time between them going out?
As mentioned if you set the refresh rate outside of what the monitor will sync to then yes it can damage the monitor.
You may need to have grounding from the wall outlets checked.
Video cards are not that expensive try another.
by swomack
by kiwimagic
Unlightly, but not impossable.
It is known, that display cards, can produce refresh timings outside meany monitors capabilityies. And there was a virus that did this, causing some monitors to burst into flames (though I have never seen this myself). Ensure that the display's refresh timings are not excedded. And if your keen and your monittors are old, check inside for dust (WARNING, leathal voltages exsists within monitors, from hours to days, after last use! And shock could kill, cause broken boans, and inflict burns that take years to heal) and remove.
by swomack
by swomack
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending