Can't configure more than one switch port 2950
When I try
conf t
int range f0/5-12
(to configure 5-12 port i.e. put into a different VLAN, I receive message)
Invalid input detected at '^' marker.
Please some one help.
Networks
When I try
conf t
int range f0/5-12
(to configure 5-12 port i.e. put into a different VLAN, I receive message)
Invalid input detected at '^' marker.
Please some one help.
by muddin Accepted solution
by netman1958 Accepted solution
between the numbers and the dash like this:
SW2950(config)#int range fa0/1 - 12
by muddin Accepted solution
space did not help
??
by netman1958 Accepted solution
SW2950(config)#int range f0/1-12
^
% Invalid input detected at '^' marker.
SW2950(config)#int range f0/1 - 12
SW2950(config-if-range)#
Are any of ports 5-12 on your 2950 part of an ether-channel or trunk?
by muddin Accepted solution
No there is no trunking port in the switch. It is the only switch in my small network. I have got the switch from friend of fine. How can you check if there is any trunking port in the switch?
Best Regards.
by netman1958 Accepted solution
run this:
"show interface trunk"
Maybe if you post your entire config we can spot something.
by muddin Accepted solution
by netman1958 Accepted solution
According to the config you sent me, you are running IOS version 12.0. Most likely it is a version earlier than 12.0(7)XE which was the version that introduced the "interface range" command. See this article for more info:
http://www.ciscosystems.com.ro/en/US/docs/ios/12_1t/12_1t4/feature/guide/range.html
by netman1958 Accepted solution
Post the output from:
"show interface trunk" and
"show run"
by muddin Accepted solution
The article link does not work. Is there any way IOS can be upgraded to 12.0(7)XE or greater?
------------------------------------
I found a link below, please check and let me know if this the right IOS for my 12 ports 2950 switch. I still need to know how to install on the actual switch though.
http://tools.cisco.com/support/downloads/go/DownloadCart.x?imageGuId=7A03D36DCD3EE44732819E7A8ADE663729DE5901&action=d
by seanferd Accepted solution
Perhaps try again.
Hopefully NetMan can answer your last question.
by netman1958 Accepted solution
Cisco doesn't give away IOS upgrades (come to think of it, Cisco doesn't give away ANYTHING). In order to upgrade your IOS, you need to have or purchase a SmartNet contract on your device. Then you will be able to login to Cisco's download area and obtain the latest IOS image for your device.
Once you have the image downloaded you place it on a tftp server. You install it on the switch by copying it from the TFTP server to flash on your switch with this command:
"copy tftp flash"
You will be prompted for the image file name, IP Address of the tftp server, etc.
Before you choose an image, be sure to check the specs for that image to see how much RAM and Flash memory it requires. If your switch doesn't have the minimum, you must upgrade your hardware or select a different image.
This discussion is closed to new replies.
Sort by Trending