Networks

Ask something
Discussion Locked

Can't see all computers

0 helpful
1 reply

by ajc718

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 IP ranges on my cisco router and put an IP address from each range on all computer's I want to see each other but olny see some. Could someone tell me if this can be done.Logically I thought it could.

1 reply

by sysnetmgr

Are you running more than one domain? Run a dos prompt and run ipconfig and see what IP addresses have been assigned to the computer, check the subnet mask, gateway, wins etc. We have VLANS and works fine - but with windows 2000 we find sometimes we have to release and renew the ipconfig before it will talk to the network again.

This discussion is closed to new replies.