Question Locked

Cisco 1721 Console Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been trying to access a Cisco 1721 Router with a console cable. I tried using two console cables, both Hypererminal and Tera Term, and double checked the settings on these. All I get on the terminal screen is the following:

A#a+J ?#)i+k!?!kaR?
!aPc??)+!!i
H#??kkJc??????????????????????????????????????????
????????????????????????????????????????????????R?#aZ)a)k?@I!H

#koX"
kHa
ZAiaS ????????
?w??????????????????????????????????????????????????????????????????????????????
???????????+)}?????????????k??9?????????)????)??9)???????6???k?h?8??????
?i??????
??????

5 replies

by photogenic memory

I just bought a 1720 off of Ebay and have no cable to connect to it to test and login. The directions online say to craft one end of an ethernet cable as a patch and the other end needs a DB9 connector. I don't have one. Can I connect to through another means?

by gregoryaspencer

I think you can use a rolled ethernet cable and connect to the aux port. All you do is reverse the pin-outs on one end of the cable.

by gregoryaspencer

Use these terminal settings:

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control

If you still get garbled, try adjusting the speed to 19200 or 1200 and try again.

by alban.fetahi

i have the same problem when i try to connect to console port a see all this

??????????????????????????????????????????????????????????????????????????????
???????????+)}?????????????k??9?????????)????)??9)???????6???k?h?8??????
?i??????
?????? ??? ?????+??[????
4???h?????????)h??????????-????????
??l?,??,???(??,???(????(o??????)h???{????y??j?#?H?
j?)#a!ASBBHa
c!#R!aPHH`!z!+Aj?)#

If anyone can help

This discussion is closed to new replies.