Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My serial Interface in the Router is saying Administratively down. How can I bring it up ?
1 reply
by it cowgirl
1.log into the console port of the router or telnet
2.enable
3."type the password"
4.conf t
5.int "whichever interface you are trying to bring up (ex: int se1/0 or int fa0/24 etc)"
6.no shut
7."ctr key"+z
8.save run start
This assumes you have already configured the interface to behave in the manner you desire. Here is the Cisco link to the configuration guide for the 1751 router:
http://cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_book09186a0080089526.html
good luck!
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies