General discussion

Locked

Cisco 1900 Hub Config

By jackie_wong ·
I want setup new Cisco 1900 switch hub. How can do you. Did you need using specily software config. I cannot using telnet config. How the default IP form cisco hub. I cannot using console config. Could you mail detail config guide to me.

RegardsJackie Wong

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Cisco 1900 Hub Config

by net_know In reply to Cisco 1900 Hub Config

Hello Jackie,

The short answer is that you need to build a minimum config on the Catalyst switch, then you can telnet into it. Here is a link to the config guides for a 1900 switch.
http://www.cisco.com/univercd/cc/td/doc/product/lan/28201900/1928v8x/
I hope this is OK. If you have a problem then drop me a line.

Regards,

Peter Groom
Network Knowledge Limited (network management specialists)
http://www.net-know.co.uk
pgroom@net-know.co.uk

Collapse -

Cisco 1900 Hub Config

by jackie_wong In reply to Cisco 1900 Hub Config

Poster rated this answer

Collapse -

Cisco 1900 Hub Config

by jackie_wong In reply to Cisco 1900 Hub Config

This question was closed by the author

Back to Desktop Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums