Question Locked

cisco 2600 no encapsulation in subif config mode

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm trying to enable intervlan routing on a cisco 2620 using IOS 12.2(5d)

when i create subinterfaces on a FastEthernet int and try to enable dot1q encapsulation i get the following:

**********************
Router(config-subif)#encapsulation dot1q 1
^
% Invalid input detected at '^' marker.

Router(config-subif)#encap?
% Unrecognized command
**********************

IOS 12.2 supports ISL/dot1q. why would encapsulation options not be present in subif config mode?

#show ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(5d), RELEASE SOFTWARE (fc1
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 02-Feb-02 03:36 by kellythw
Image text-base: 0x80008088, data-base: 0x80989870

6 replies

by juan.ferreiro

you must create subif first.try this:
interface fastethernet0/0.1
encapsulation dot1q 1 native
ip add 192.168.1.1 255.255.255.0

my subinterfaces work fine when they are created in this way.

by ahmed.baha

I have the same Problem on my Cisco3620.

The "encapsulation" command doesn't exist in the IOS despite that cisco site says it does.

the funny thing is that when I try to simply give an IP to the Subinterface, I get the somrthing like this:

You can't add IP addresses to subinterfaces unless you're using dot1q, 801.2, ISL vLAN.

Can someone help please?

by gregoryaspencer

It depends on which image you have loaded in flash. I am running into the same problem on a 2600 and I am having to upgrade the flash to make room for an image with more features.

by t

are you running 10mbs (Ethernet) or 100mbs (fastEthernet)? If running only at 10mbs, I believe that encapsulation is only offered on cards running 100mbs or faster. Just a thought

by gmlynx

As the prevous post suggests this will only work on a Fa port.
Was having exactly the same problem until I read and tried the suggested fix.

Worked first time!

Thanks guys :)

This discussion is closed to new replies.