Question Locked

Cisco Catalyst 2950 and Intertel IPRC cards

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We made a change from Netgear switches to Cisco 2950's to upgrade our network, and now we are having intermittent problems with our Intertel IP phones cutting out. We are also having problems with our RFID readers timing out while reading tags. How should we have these switches configured? Didn't have this problem on the Netgears. Any help would be appreciated.

3 replies

by netman1958

What model Netgears were you using. Did they have QOS configured? Do the Intertel phones tag their traffic for QOS/COS?

Here are some options on a 2950 interface:

SW2950(config-if)#mls qos ?
cos cos keyword
trust trust keyword

SW2950(config-if)#mls qos cos ?
<0-7> class of service value between 0 and 7
override override keyword

SW2950(config-if)#mls qos trust ?
cos cos keyword
device trusted device class

SW2950(config-if)#mls qos trust device ?
cisco-phone Cisco IP Phone

I doubt you can use "mls qos trust device cisco-phone" unless the Intertel phones support CDP. But you could just use "mls qos trust cos" and if security is an issue, you could use port security on the ports the phones are connected to.

by Former member

But still, a noted answer. Considering that the lazy Netgears handled everything without QoS..

What I would do is look at all of the interfaces and look for any errors, such as interface errors like....uh....I forget. Oh yeah, like checksum errors or particularly lots of collisions. It would not be uncommon for you to have a negotiation mismatch on an interface, especially if you use "auto negotiate" on the interfaces and the devices. That's where I would start. Also any time you connect and disconnect connections, there's always a chance of bad cables cropping up. The errors will tell you that as well.

This discussion is closed to new replies.