Discussion Locked

Cisco Nat Issue

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to clear the NAT translation table in my router sometimes two times a day. IP NAT timeout is set to 60. Other than not having enough dynamic addresses, what else can be causing this? I can trace a few local users whom are heavy hitters and they do experience a lot of spam and pop-ups. Could they be the direct cause?

1 reply

by vmwarez

I've seen the same thing too... usually it turned out to be a computer on the inside infected w/ a virus OR, get this.... someone had a sharp zaurus pda (linux based)... the cradle was plugged into their pc via usb and they had all their software loaded on the PC. when the pda is on the cradle, it does this ppp over usb thing using private addresses (192.168.xxx.xxx)... when the pda is not plugged in, the software on the pc sends out these little heartbeat packets to see if the pda is docked... but since it isn't, the packets go out the default gateway of the lan connection instead of the pppusb thing. it was happening so often that it was filling up the cisco nat tables.... i uninstalled his softare and the problem went away. So, i'd look for something on the inside that is trying to connect to something on the outside that doesn't exist.

Hope this helps.

Jim

This discussion is closed to new replies.