Discussion Locked

Cisco router

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I was ask to make data a first priority in the router. I would like to know were I could get information to set this up in my router. I would also like to know how I would setup a T1 and PRI, ISDN in my router. Need help.

1 reply

by mshavrov

It's very broad question. Basic answer is "Look for QoS (Quality of Service)" topics at the Cisco.com

Basically there are a different techniques and technologies for different type of traffic. For a local queueing you may split traffic to a different queues, and based on queue type and priority your one traffic will be transmitted before another, they may be interleaving, etc.

Another area is setting your end-to-end traffic priority - then you use traffic marking, and one type of traffic may be treated differently than another type.

If you have Voice traffic you should take care of, then you may be needed to set different combinations of these basic technologies, etc.

Here is a link on the Cisco.com with all categories of QoS:

http://www.cisco.com/en/US/tech/tk543/tsd_technology_support_category_home.html

Good luck,

Michael Shavrov
CCNP, CCDP, CCSP, Voice Specialization, MCSE+I, MCSE W2K, Security+, etc.
http://www.ciscoheadsetadapter.com

This discussion is closed to new replies.