Question Locked

Cisco SOHO97 Router - Can't establish connection

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have the router as listed in the title. However upon inserting the ethernet cable it does not establish a connection and continually has "acquiring network connection" or similar as the status on the computer.

I have tried setting a static ip address, however I still cannot seem to access the router at it's default address as well as other suggested addresses I have found on the internet.

I have purchased it off someone else, who will not give me any support and said that it was working fine on his network. It did not come with a manual, although I have found some information similar on the net to help, but have not come at a solution. I have tried multiple computers.

Default address for this router is 10.10.10.1 as found on cisco website.

Would appreciate any help.

8 replies

by Former member

It does say that you will be connected in about one or two minutes.

Please post back if you have any more problems or questions.

by bfisher108

>> It does say that you will be connected in about one or two minutes.

Sorry, don't quite understand what you mean.

by dumphrey

Content deleted due to being irrelevant
[edit2]
wow. my answer in no way reflects your question.. Its time for more coffee.
Can you access it via serial/console? Its possible it has SDM disabled or limited to a specific host. Next poster recommended a clean config, and I would have to second that.

by shhite

Did you reset the router back to default factory seetings and start from scratch? There might be one setting that is preventing it from connecting to your network.

by bfisher108

Good idea, I was thinking I should do that. I would have to do that via console? How do I connect to the router to access it via terminal? Do I need a special cable, or will a standard ethernet do?

Edit: Ok, I'm going to get a console cable off the seller. Apparently as the seller said he "wiped the config", it might mean I'll have to configure it from scratch, but I'm not sure, better would be if wiping meant overwriting with default and not deleting.

Anyone that could help me with this? A website or instructions? All I really need to do is configure it enough so that it will assign an IP address to my computer through DHCP when I plug it in, and anything else that needs to be configured. Then I think it has a web interface I can use to simplify things a bit.

by bfisher108

Worked it out. Pretty straight forward. Set up the basics through console which brought the lan up, allowing me to do the rest in the web interface. Just have a problem not able to access any websites although I have been allocated an ip by my isp.

This discussion is closed to new replies.