Configure Single DHCP pool on multiple switches

By m_abideen ·
am going to add another site to existing network, Additional site will eb conencted by means of MPLS. ethernet cable from MPLS router will connect to one of the switch

i will have 4 2960 switches there connected each other

Single VLAN

i want to configure these Switches as DHCP Servers

I am able to configure succesfully the DHCP pool by using ip dhcp pool command

My Question are:

DO i need to create DHCP pool on each swichtes?

Do i need to configure the same command on all swotches or i can configure one switch as DHCP and computer conencted to other switches will take the IP from this switch.

My objectives are:

The computers connected to all switches canget the IP address thorugh DHCP

Thx and Regards

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

DHCP Pools

by scott_heath In reply to Configure Single DHCP poo ...

You do NOT want multiple DHCP pools. The each have a separate database that tracks IP assignment so you'd end up with multiple systems with the same IP.

I am not a Cisco Network Engineer, but I believe you will need to set the VLAN designation on each switch port, although it may default to VLAN1. Check out the VLAN config docs at the link below.


Back to Desktop Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums