Question Locked

Configuring CISCO router thru serial port in RH Linux

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I am trying to configure a CISCO router through serial port in Red hat Linux.
I tried using minicom and cutecom, but i am unable to detect anything in the interface.
The following is the setting, that i configured for both minicom and cutecom.
Serial Port: /dev/ttyS0 (I have also tried with ttyS1 ...)
Bps/Par/Bits: 9600 8N1
No Flow Control

Can anybody throw some light on it..

Thanks,
Parthiparaj

5 replies

by cg it

if it's a 2500/2600/2800 use the console port.

the problems with the serial port is you have to use null modem

by parthiparaj

Its a 2600 series Cisco router..
i used the console port and result is the same.

by madeldcs

Hello,
Please make sure that the comport is enabled from the BIOS

This discussion is closed to new replies.