Discussion Locked

Connectin an access point to Cisco 837

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

Can I connect a wireless Access point to one of the ethernet port on a cisco router 837?. so i could use my laptop around the house

1 reply

by bobtheitbuilder

There should be no reason why you can't. Assign an IP Address/SNM to the ethernet port on the router as per normal and then on the W-AP issue a static IP within the range of the routers subnet (next available) and then on the AP enable DHCP with a scope range of the subnet minus the static one issued to the AP and ethernet port. Good luck

This discussion is closed to new replies.