Discussion Locked

Connecting a wlan pci card to a thin client

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's my situ :

a. I have a couple of wyse 3125 thin clients with 2 usb ports.
b. I also have a couple of 108 wlan pci cards 802.11g that i had removed from my desktops.
c. I dont have a wired net connection.
d. Is there any usb device into which i can insert the pci wlan card and then plug it into the thin client rather than buying a usb wlan ?
e. If not, any other solution to use these wlan pci cards as i wont be buying any more desktops ?

Any and all advise welcome !

Thanks
Swati

2 replies

by carlitosway

I think that you should go with USB WLAN. No sense in wasting youre time trying to find a way around the pci cards. There really not much you can do with them right since you have the wyse clients.

Just make sure that the thin client can support the USB WLAN. I was on the site and I saw that they had a USB wireless option that was rated at 802.11B, not G. They have documentation on the site and you can also call up a wyse tech to make sure.

Here the site address:

http://www.wyse.com/products/winterm/3125se/index.htm

For question e.) .......Sell them on ebay ;)

Hope this helps,

Carlitosway

by cp7212

I support a small network of Neowares (fat clients) and we are limited to 802.11b because the USB ports are USB 1.0. I'm not sure that you can use 802.11g with anything other than USB 2.0. We use Dell TrueMobile 1180 USB antennas on the fat clients. They work pretty well, considering we have an inhospitable wireless environment.

However, most USB antennae that you will use for wlan uses 500 mAmps. That is what a root hub (two USB ports) uses. So if you plug one of these into one of your two ports, that is all you can use. If you plugged something else in the other port, it will drain energy from your antenna.

I don't know of any PCI to USB adapters. Good luck.

This discussion is closed to new replies.