Discussion Locked

DB15 Monitor Configurations???

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can anyone give me a copy of pin configurations of db15 monitor. I have searched the net but didnt see anything that would help me.. What I need is the wire confirations of monitor, not the pin. I need to solder the wire of my old monitor in a new connector case but dont know teh configurations of the pin .. Please help...

2 replies

by sgt_shultz

see if this helps:
support.gateway.com/s/MONITOR/shared/vcpins1.shtml
remove any spaces that appear in url, etc etc

by thechas

Let me verify this, you have a monitor with a cut or missing cable, and need to hard wire the cable to a new connector.

There is no 'standard' color code for the wires in the monitor cable.
To be assured that the monitor or video card will not be damaged, you will need a service manual for the monitor so you can trace back each wire to the signal and then connect it to the proper pin.

CAUTION: If any signal line is mis-wired, you can destroy both the monitor and the video card!!!!

That said, you may get "lucky". There are informal standards used by the electronics industry. If the company that made the monitor cable followed these standards, the wire color to pin number might be:

Brown 1
Red 2
Orange 3
Yellow 4
Green 5
Blue 6
Violet 7
Gray 8
White 9
Black 10
Brown with a stripe 11
Red with a stripe 12
Orange with a stripe 13
Yellow with a stripe 14
Green with a stripe 15

CAUTION: Even if the colors are present as listed above, you still need to trace back a few lines to the circuit board inside the monitor to verify that the signals are correct.

CAUTION: There are high voltages present inside a monitor. Even if it has been off for a number of days. The CRT could have 25,000 VOLTS on it.
USE EXTREME CARE when working inside a monitor.

Chas

This discussion is closed to new replies.