detailed cable-connection.

Hi First things first the television has a horizontal scan freq of 15.625 kHZ if it is used for PAL colour system ie UK or 15.750kHZ if NTSC ie USA unless it has 100Hz flicker free technology in which case it runs at twice the above freq's, so unless your card sends out TV scan rates some combined tv/video cards do you cannot use it.
VGA 640x480 at standard refresh is at 31.5kHZ horizontal and 60Hz vertical and all other modes are higher still.

Any how the connections on the 15W is as follows
1 Red signal
2 Green Signal
3 Blue Signal
4 not required
5 not required
6 Red Ground
7 Green Ground
8 Blue ground
9 not required
10 Sync Ground
11 not required
12 not required
13 Horizontal Sync
14 Vertical Sync
15 not required

also not all scart i/p will accept RGB but require composite video I hope your manual will give the connections for your scart if not searching on the net will give you what all the pins are supposed to do but it is unusal for all to be implemented.

Best Regards

R.K.Barsby

Point value changed by question poster.

Hi its me again here are the connections

15W Scart
1 15
2 11
3 7

6 13
7 9
8 5

10 18

Pins 13 & 14 on the 15W have to go through an and gate to mix the horizontal & vertical syncs together and fed into pin 20 ON THE SCART connector, I still have the same reservations as before. I have been in the monitor industry since 1978.

Best Regards

R.K.Barsby

To get around the synch problem, you are going to have to swap the Video Card.
This is not a big deal, Video cards are cheap.
Try ebay.
Regards, Chris

This question was auto closed due to inactivity