General discussion

Locked

DHCP server problem

By waqasanwari ·
I have two labs(lab1 & lab2);I have a DHCP Server on lab1.I have created a super scope.I want that my dhcp server assign ip-addresses(192.168.0.1 to 192.168.0.250) to lab1 computers and ip-addresses(192.168.1.1 to 192.168.1.250) to lab2 computers.
But it does not happening.
What else should i do.
Plz help me.

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by djrampant In reply to DHCP server problem

You need to install the DHCP relay agent in lab 2. This will then forward the dhcp request packets to the server in lab 1 so it can assign addresses.

This is done using routing and remote access.

Good luck.

Collapse -

by wmr02 In reply to DHCP server problem

You could set up a router with bootp forwarding enabled. Hand the switch(es) for lab1 of one interface, and hang the switch(es) for lab2 of the other interface. Set the Interface for lab 1 to 192.168.0.1 and lab 2 to 192.168.1.1 and revise your scopes so that the .1 addresses are not assigned. Also set the deafault gateway for eachscope to be the.2 interface.

Collapse -

by waqasanwari In reply to

Poster rated this answer.

Collapse -

by waqasanwari In reply to DHCP server problem

This question was closed by the author

Back to Networks Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums