Networks

Ask something
Question Locked

Ethernet Link Aggregation

0 helpful
2 replies

by Member 29718538

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to do static link aggregation (no LACP) on Cisco & Netgear switch. In both cases, if I disconnect link within group, traffic switches to other link. If both links are connected, in Cisco, traffic load balances between both links (as expected) whereas in Netgear, traffic is only on one link & BW is limited to one link. Do all switched do load balancing between links within static aggregation group, and if so, what might my problem be?
Thanks

2 replies

by vitesh.acharekar

Hi Josh,

Got to read abt your post here. I am trying to do the Ethernet link aggrigation on WAN.
Both ends have Cisco 3560 switch. I have configured etherchannel but I dont see data flowing on both the links. You have said in your post that with your configuration you can see data flow on both links at a time. Could you please share the same configuration.

Thanks
Vitesh

This discussion is closed to new replies.