Networks

Ask something
Discussion Locked

Ethernet Link aggregation

0 helpful
1 reply

by vitesh.acharekar

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have two locations "A" and "B" connected with 2 point-to-point links from two different service providers. Both links are of 10Mbps.
At both ends links are terminated on Cisco 3560 switch. I want to acheive 20Mbps of throughput at a time and link failover between two links.
I tried configuring Etherchannels but data moves only one link. Lik, one link only serves Sent traffic and other only receives. Also, during failover one of the links fails to come UP at one end.

Any help will be appreciated.

Thanks
Vitesh

1 reply

by boxfiddler

where we gather to discuss all sorts of stuff, both tech and non-tech. The folks who answer questions don't often frequent Discussions as they are on the Questions Forum answering Questions.

You may or may not get an answer here in Discussions. You are much more likely to get one by reposting to the Questions Forum.

That would be the 'Ask A Question' button, located directly to the right of the 'Start A Discussion' button.

This discussion is closed to new replies.