General discussion

Locked

Hardware--Video

By ChrisIS ·
Trying to determine what Omniview device to purchase. One states it handles resolution from 1280 x 1024 at 80Hz and the other 1600 x 1200 at 65Hz. If you run your desktops at lower than 1280 x 1024(as most do) does the Hz have to be set 65 and below for the one model to work? if so would the other one that supports 80Hz supports all Hz up to 80. And is this more exceptable model(the one that supports 80Hz)

Thanks

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Hardware--Video

by tchieng In reply to Hardware--Video

Those numbers are just MAX resolution that the device is capable of. Any good quality video device these days will support up to and beyond the 80Hz at 1280 X 1024 and lower resolutions.

Collapse -

Hardware--Video

by ChrisIS In reply to Hardware--Video
Collapse -

Hardware--Video

by resmith In reply to Hardware--Video

We purchased some overhead projections for our operations floor. Anyway, I think you are looking at a similar system. Output from desktop to projection system?

I would recommend the 80hz. We purchased 4 projectors, and to use them to display our desktop screens we had to painfully lower our resolution and refresh rate Hz. It really lowered their functionality for us. I would recommend the extra cost of the 80hz device so that you will be sure to not have to adjust your systems.

Collapse -

Hardware--Video

by ChrisIS In reply to Hardware--Video
Back to Desktop Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums