Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have a server that we want to run a heartbeat between the two nic's onboard and we run each nic to a separate 3560 switch that are linked together as well. We are using the latest version of Red Hat. We have tried bonding the nics together which has worked but it sends the same mac out to both switches confusing them and therefore shutting one port down. is there a way to run the heartbeat between them but have them set up for one to take over the traffic if one nic fails and assume the ip address as well.
3 replies
by mariner792005 Accepted solution
Clarifications
by robo_dev Accepted solution
http://web.bii.a-star.edu.sg/~tanyh/bonding.txt
Some linux ethernet drivers used for bonding allow you to chenge the mac when failing-over, thus eliminating the duplicate mac issue.
(fail_over_mac option)
by pnoykalbo Accepted solution
What mode did you setup on your bonding? If you use round-robin, it will have the same mac. Try using mode 6, adaptive mode.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies