Discussion Locked

Help on Gateway Astro Monitor

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Please read my article entitled Too Much Technology in the Discussion Area. A working solution to control of the monitor will get the points!

10 replies

by guruofdos

The budget for this project only allows ?100 ($142) and I'm in the UK so scrub Ebay for time and shipping reasons! Money has already been spent on the new mobo. Deadline for completion of the refurb is 4 June! Thanks for the comments though.

by thechas

Here's my best suggestion to use what you have set up.

This is from a TechProGuild article.

Create a custom monitor driver for your users with a shareware utility called PowerStrip from EnTech Taiwan. Use PowerStrip to compensate for any abnormalities in the way that users' monitors display colors. (You can download PowerStrip from CNET's Download.com for a $29.95 registration fee.)

http://www.entechtaiwan.com/
http://download.cnet.com/downloads/0-10106-100-7656924.html

I checked the link to entechtaiwan, I think this utility may just be able to do all that you need.

Chas

by guruofdos

This utility does not allow control of hardware functions of this monitor. That is, brightness and contrast, power on/off etc. The Astro monitor PCB has an I2C chip custom programmed for this application and Powerstrip does not recognise it in it's database.

by thechas

Okay, let me ask a couple of questions.

Does the monitor use just the standard VGA connections to the motherboard?

Or is there an extra set of wires for the control circuit?

If there is an extra set of wires, (or a spot for an extra connector of the board) you may be able to take a control panel from a monitor, and figure out how to wire the key matrix to the control board.

I would start by opening up a stand alone Gateway monitor of the same "vintage" as the Astro, and see if it has a similar circuit card.
If so, then it should be a simple matter to "reverse" engineer the keyboard and connections.

Chas

by guruofdos

Standard HD15 D Type monitor connector. Uses standard DCC1 and DCC2 pins for communication. Using a standard VGA monitor results in Windows (98SE) detecting a Default Monitor. Reboot using the Gateway and it is correctly identified by make and model, so DCC is working.

by guruofdos

Tried that, but it is for the Intel 810E chipset on the original mobo. My replacement mobo has a Trident Blade 3D graphics chip.

This discussion is closed to new replies.