Discussion Locked

Help Troubleshoot Install of Harddrive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an HP Vectra PIII 500 Mhz. I installed a new 30GB harddrive but I can't get it to boot. I am getting one long and 2 short beeps which led me to believe the video card (built in motherboard) was bad. What is my next step? I am very new at IT and will appreciate any help. I have tried reinstalling the drive and attempting a boot from a recovery bootdisk. Thanks.

7 replies

by dmiles

The one long-two short beep code does point to video circuitry problems
Using a seperate card install on motherboard at available PCI or AGP slot

Boot computer and enter the BIOS configuration and disable the onboard video,then proceed to install the video drivers for the card

by thechas

I would double check the drive jumpers and cables.
If you installed the new drive as a slave, make sure that you changed the master drive jumpers to master with slave (usually different than without slave)

Double check that you did not disturb the system ram, or any cables or jumpers on the motherboard.

It's even possible that the monitor is not plugged all the way into the video connector.

Chas

by j_o_blair

it may also be that there is a flaky connection from the board to the vcard.
one thing to attempt is to leave the machine on after the post errors... for about 5-10 min then hit reset.
I've got two machines here with the same issue. Seems to be related to how cold the board is.

this will let you know for sure that it is related to socket creep with the video card.

If it still doesn't work, try flashing the bios and see if there is any change

This discussion is closed to new replies.