Question Locked

How can I switch ISP's with minimal downtime/switchtime?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Currently running on a cable ISP with two static IP's sNAT'd to inside servers. We will need to switch our A/MX records to the new IP's (on a T1). My thoughts were using a router that supports two internet connections and just setup the SNAT on both connections to point through. Other thing I want to look out for is getting listed as spam when the mx record changes over (spf records will have to be updated "on the fly"). NOTE: we won't be switching dns hosts.

4 replies

by pshiflet-24

Well, unless you already have a device that supports multiple WAN connections or want to use one long term, I wouldn't buy one for this. First, I would have the new provider deliver the service to your location so that to utilize it all you have to do is modify your router config and plug it in. This way you can have both services available, one in use, until you are ready to switch. Then, at least 24 hours before you are going to switch, modify the TTL for your DNS records to something really short, like 5-10 minutes and modify your SPF record in use to include IP information for both providers (or you could just remove the SPF record for a few hours or days, since very few people out and out block senders w/ no SPF record). Then, modify your DNS records, adjust your router config (upload a pre-changed one if possible, or make the few adjustments manually if needed), and cut over to the new provider. Once that is done you can modify the TTL for you DNS records to something more reasonable, such as 12 or 24 hours, and adjust or re-add your SPF record as needed.

Let me know if that helps or you have further questions. Thanks.

by bill

I hadn't thought of doing it this way since I don't have direct control of the DNS records. Although the support department of the host is very accommodating so I'm sure these steps would be possible.
This is a much simpler solution than what I was looking at! Our current router is a Netopia r910 and I reaaally need to get rid of it (the collision light is more like a strobe light these days). I'm looking at using the Astaro software appliance in the meantime until the budget allows for some bigger steel.

Thanks again... very helpful!!

by pshiflet-24

Always glad to offer help when I can. Let me know if this works out for you or you have questions later on. Also, I actually used one of those old Netopia routers (r9100) for a number of years. They are fairly robust for what they are but you are right - they don't always age gracefully.

An alternative to Astaro you may want to look at is Untangle. They also offer a free for business software option if you have the hardware to load it on. Anyway, good luck and let me know if you ahve any questions.

This discussion is closed to new replies.