Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a broadband connection with a static ip i have con figured tht in a cisco 1841 series router and everything is working fine .now i want to restrict the internet to limited user from my internal network.I also want to enable http for a particular website only
3 replies
by sobhan1974 Accepted solution
Clarifications
by peconet tietokoneet Accepted solution
by defrey74 Accepted solution
You need to create an ACL (Access list)on the router interface to deny/allow traffic incoming or outgoing
Note that you can configure 2 types of ACL, but i recommend Extended ACL
eg:
-> Configure your ACL
R1(config)# access-list 101 permit tcp "network address" "wild card mask" any eq 80 (any eq mean port number)
you then need to apply the list to the interface:
#interface fastEthernet 0/1#
#ip access-group 101 out (outbound)
#ip access-group 104 in (inbound)
Good luck
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies