Discussion Locked

How to test a motherboard?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My computer will go into a 5 hour scandisk session each time I boot up even after a normal shutdown. I replaced the hard drive and noticed that it took an extremely long time for fdisk to create a new partition. Is it possible that the motherboard is bad? Should I install a hard drive controller card to correct the problem? Any suggestions?

7 replies

by borginva

It is very hard to test a mother board unless you have the proper equiptment or send it to a repair ($$$) shop. If your mother board is an older one, you might want to look itdo an upgrade and reap the benifits.
If it is a newer board, I would see the problem in either the controller card or the mother board itself (in the controller port/slot or elsewhere on the board).
Try replacing the controller card first. It is the cheapest way (and you can always return the card if it does not work).
Give it a try.

by thechas

It is possible for the motherboard to be bad.
It is more likely, that the CPU or memory has a problem.

There are numerous utilities that can run performance and burn-in tests on a mother board.
One I have used is Check It.
I think they ar enowpart of Smith Micro www.smithmicro.com
You can run a "burn-in" from a DOS floppy.

There are numerous causes for scandisk at boot. If you are running Windows 98, you should install the large hard drive cache supplement via Windows Update.

Chas

by tsweany

I would check your BIOS settings and update the BIOS with the latest version. Usually available to download from the manufacturer of your motherboard. Depending on your motherboard, there can be many setting in BIOS that can cause confusion and chaos.

This discussion is closed to new replies.