General discussion

Locked

HP Omnibook Xe3 GF USB to Serial Port

By dcook ·
Has anyone had a problem and a solution in using the HP Omnibook Xe3 Laptop USB to Serial dongle. Under Win98 SE it creates a virtual COM1 port in place of the hardware serial port used on the GC series notebooks. My problem is that it works fine with an external modem and my digital camera but not to connect to a PLC allowing programming, setup and manipulation of building automation control systems. The PLC's work great with the hardware COM1 but not with the virtual COM1. I've obtained the latest drivers fron Xircom and still have the same problem. I even tried reassigning COM ports. No go! Please help. HP says "?".

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

HP Omnibook Xe3 GF USB to Serial Port

by velvet4uonly In reply to HP Omnibook Xe3 GF USB to ...

Sometimes you have to use the usb...have you tried using that approach?

Collapse -

HP Omnibook Xe3 GF USB to Serial Port

by dcook In reply to HP Omnibook Xe3 GF USB to ...

Poster rated this answer

Collapse -

HP Omnibook Xe3 GF USB to Serial Port

by dcook In reply to HP Omnibook Xe3 GF USB to ...

This question was closed by the author

Back to Desktop Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums