16 replies
by dklippert
Try disconnecting the printer and running a self test.
Try using a different computer.
Try a different printer cable. (probable cause)
If this doesn't work, please post your Operating system and printer type.
Good luck
by dklippert
by thevirussoul
by ojmj
Hate to ask the obvious, but have you moved your printer or CPU lately?
It is possible that the printer cable itself is loose or damaged. Replace it with a known good printer cable, securely fastened to the CPU and the printer.
O.J.
by thevirussoul
by ojmj
Hate to ask the obvious, but have you moved your printer or CPU lately?
It is possible that the printer cable itself is loose or damaged. Replace it with a known good printer cable, securely fastened to the CPU and the printer.
O.J.
by thevirussoul
loose or bad printer cable.
install new printerdrivers.
or if its a matrix printer , the baude rate between the printer and the pc dont match.
If the selftest prints good, you will know its a software issues, else its the printer itself.
regards,
Leopold
by thevirussoul
by gijoe
See if the printer works properly when directly connected to another computer. If the problem follows the printer, it may be that the logic board on the printer has shorted. If the printer works fine and another workstation then it points back to your computer.
Have you updated NAV to the most current Anti-virus definitions and run a complete scan on this system?
by thevirussoul
by jereg
by thevirussoul
I think it may be a bad printer cable. Do you have a bi-directional cable if one is required? It could also be faulty printer memory.
Maxwell
by thevirussoul
by thevirussoul
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending