Discussion Locked

IBM Blade Centre Management Module

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have a problem with an IBM blade Chassis. It is configured and on the network but when you power up a blade you get the error
i9990306 timed out waiting on MM:system halted in post
Has anyone seen this before. I cann't find the code on IBM's site and wondered what it meant/what the solution might be.

7 replies

by jconaty

Have you found an answer to this problem ? I am having the same issue. it started after the IBM engineer had me flash the HS20 blade from the MM. I have had a case open with IBM for 3 days now and have gotten no where. I am also having issues with the KVM in remote control. Most times it doesn't work at all.

Thank you.

by nick-techrepublic.com.com

I had this problem as well.

the answer I found was to take the blade out of the blade center and then press the path diag buttons inside then put it back in to the blade center.

comes up with a config error but after that it works with out issue.

by ilserver

Hi. I had solve the same problem due perform a firmware upgrade of the MM. The problem is that MM is not shipped with firmware that is not ok at 100% for HS20 blade.
This is FW level that I have ulpoad:
Main application|BRET82H|CNETMNUS.PKT|12-07-05|16

Bye.

by attila.juhasz

Sorry this simple question but how you could update the FW. Because we can't use our CD drive our Floppy. Is there any other solution?

by matt.williams

IBM has an update on this for those of you searching on the web her
https://www-304.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5073950&brandind=5000020

There is another solution for the HS20, but it is temporary.

Make sure that you power off the blade in question and make sure that it is powered off in the remote control console. Be aware that the power status will still say on, don't worry that is normal since it cannot communicate with the BMC. Just make sure you see the standard "No display" on that particular blade module KVM session.

Grab the latest BMC update for your HS20 blade from IBM. Update the firmware thru the Blade web or console page. Once that upgrades, power on the box again (note you will now see that the device is showing as 'off'). You should be good to go.

by abraham froman

I get this error every so often when the platform groups update the firmware on their blades and one of them won't boot afterwards. I haven't been able to pin down a specific root cause as it seems to be completely arbitrary as to which blades have this problem, but I imagine it has something to do with which firmware level the blade was at and what it was flashed to and which firmware level the management module is at etc. The fix has always been to restart the blade's system management processor.

This discussion is closed to new replies.