Discussion Locked

IP configuration for Clients

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a windows server 2003. There are 10 computers connected to it through LAN.They are all sharing Files and other resources but the problem lies in internet sharing. The server has ISDN internet connection and is running smoothly on the server but not on the clients. What's the problem, can anybody help me in rectifying it?

9 replies

by rkuhn040172

Make sure they are all using the server as the gateway, all are on the same subnet, and each client is using the correct DNS settings.

by thomasjob1

Make sure all the clients have the server as their default gateway and you have to set a proxy for all the clients & a connection sharing on Internet onthe server

by bobtheitbuilder

Get rid of your ISDN and get Broadband. Get a router that controlls all clients internet access and this will save your server from unwanted processor usage. Failing that put another NIC in your server so that it is in-between your isdn and your clients and then set up NAT(RRAS) on your server. The IP address of the internal NIC will be your client's gateway IP address.

by hozcanhan

Rehana ;
1. Configure your settings about sharing the net on the server.
2.configure your defalt gateway and dns entries on the clients
3.use tracert command to see if you can reach a well known web site from your client.see where you cannot run over a hop and fix the problem

by lamczyknic3000

Is your modem configured correctly and are you using a router anywhere on your network. If not use your server as a default gateway. also make sure dhcp settings on your server are configured correctly, and make sure dhcp is also configured properly on the client side.

by swas786

Hi salam howru?
I want to say about ur question u should same the workgroup of all of ur computers also server. Then use the IP table of (192.168.0.1 to 192.168.0.254).and subnet mask (255.255.255.0)
each computer will be one IP Address of this table for EXp. Computer1 =192.168.0.3,computer 2=192.168.0.4 so on
after that go to internet explorer+properties+connection+lan setting then Select AUTOMATIC DETECT IP then Ok OK after this share ur Internet from server server LAN IP will Be 192.168.0.1 Ok. i think this is help ful to u Ok ALLAH HAFIZ

by swas786

Hi salam howru? I want to say about ur question u should same the workgroup of all of ur computers also server. Then use the IP table of (192.168.0.1 to 192.168.0.254).and subnet mask (255.255.255.0) each computer will be one IP Address of this table for EXp. Computer1=192.168.0.3,computer 2=192.168.0.4 so on
after that go to internet explorer+properties+connection+lan setting then Select AUTOMATIC DETECT IP then Ok OK after this share ur Internet from server server LAN IP will Be 192.168.0.1 Ok.then goto any one of ur client PC start+run then write here ping 192.168.0.1 -t it will be reply from 192.168.0.1 if request time out ur connection is not Ok. i think this is help full to u Ok ALLAH HAFIZ, IF is this not help ful to u can mail me dirctly swas786@hotmail.com

This discussion is closed to new replies.