Question Locked

Large Packets from site to site VPN not coming through

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am in desperate need of help. I've been trying to configure this 1841 Cisco Router for 2 months and can not get SMTP to route properly from our other site. Smaller SMTP packets comes through fine, but when a large email tries to come through everything stops. This also goes with any type of larger packets.
I have a feeling it may be an MTU setting or something with fragmentation, or the IP virtual-reassembly line on the interfaces.
I would greatly appreciate any help from anyone. I have copied my config. Let me know if anyone needs any more information.
ip cef
!
ip domain name fake.com
ip inspect name SDM_LOW cuseeme
ip inspect name SDM_LOW dns
ip inspect name SDM_LOW ftp
ip inspect name SDM_LOW h323
ip inspect name SDM_LOW https
ip inspect name SDM_LOW icmp
ip inspect name SDM_LOW imap
ip inspect name SDM_LOW pop3
ip inspect name SDM_LOW netshow
ip inspect name SDM_LOW rcmd
ip inspect name SDM_LOW realaudio
ip inspect name SDM_LOW rtsp
ip inspect name SDM_LOW esmtp
ip inspect name SDM_LOW sqlnet
ip inspect name SDM_LOW streamworks
ip inspect name SDM_LOW tftp
ip inspect name SDM_LOW tcp
ip inspect name SDM_LOW udp
ip inspect name SDM_LOW vdolive
ip ips sdf location flash://128MB.sdf autosave
ip ips notify SDEE
ip ips name sdm_ips_rule
!
ip tcp synwait-time 10
ip ssh time-out 60
ip ssh authentication-retries 2
!
!
crypto isakmp policy 10
hash md5
authentication pre-share
!
crypto isakmp policy 11
encr 3des
hash md5
authentication pre-share
group 2
crypto isakmp key ****** address 22.22.22.201 (2nd Location)
crypto isakmp key ****** address 62.223.29.9 (3rd Location)
!
!
crypto ipsec transform-set myset esp-des esp-md5-hmac
crypto ipsec transform-set myset3des esp-3des esp-md5-hmac
!
crypto map newmap 10 ipsec-isakmp
set peer 22.22.22.201
set security-association lifetime seconds 86400
set transform-set myset
match address 101
crypto map newmap 11 ipsec-isakmp
set peer 62.223.29.9
set security-association lifetime seconds 86400
set transform-set myset3des
match address 102
!
!
!
interface Loopback23
ip address 1.1.1.1 255.255.255.252
no ip proxy-arp
ip virtual-reassembly
ip route-cache flow
!
interface FastEthernet0/0
description outside
ip address 77.33.232.101 255.255.255.248
ip verify unicast reverse-path
no ip proxy-arp
ip nat outside
ip inspect SDM_LOW out
ip ips sdm_ips_rule out
ip virtual-reassembly
ip route-cache flow
duplex full
speed 100
no keepalive
crypto map newmap
!
interface FastEthernet0/1
description inside
ip address 192.168.1.1 255.255.255.0
ip access-group 104 in
no ip proxy-arp
ip nat inside
ip ips sdm_ips_rule in
ip virtual-reassembly
ip route-cache flow
ip policy route-map NO_NAT_ROUTE
duplex auto
speed auto
!
!
ip http server
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
ip nat pool GLOBALNAT 77.33.232.102 77.33.232.102 netmask 255.255.255.248
ip nat inside source route-map SDM_RMAP_1 pool GLOBALNAT overload
ip nat inside source static 192.168.1.2 77.33.232.103
ip nat inside source static 192.168.1.3 77.33.232.104
ip nat inside source static 192.168.1.4 77.33.232.105 (smtp and dns)
!
logging trap debugging
logging 10.31.1.19
access-list 1 permit 10.31.0.0 0.0.255.255
access-list 101 permit ip 192.168.0.0 0.0.255.255 10.10.0.0 0.0.255.255 (2nd Location)
access-list 102 permit ip 192.168.0.0 0.0.255.255 10.20.0.0 0.0.255.255 (3rd Location)
access-list 104 deny ip host 255.255.255.255 any
access-list 104 deny ip 127.0.0.0 0.255.255.255 any
access-list 104 permit ip any any
access-list 130 deny ip 192.168.0.0 0.0.255.255 10.10.0.0 0.0.255.255
access-list 130 deny ip 192.168.0.0 0.0.255.255 10.20.0.0 0.0.255.255
access-list 130 permit ip 192.168.0.0 0.0.255.255 any
access-list 131 permit ip 192.168.0.0 0.0.255.255 10.10.0.0 0.0.255.255
access-list 131 permit ip 192.168.0.0 0.0.255.255 10.20.0.0 0.0.255.255
no cdp run
!
route-map NO_NAT_ROUTE permit 1
match ip address 131
set ip next-hop 1.1.1.2
!
route-map SDM_RMAP_1 permit 1
match ip address 130
!

3 replies

by Former member

First thing I would do is debug the console logs, watch them roll along as the traffic is trying to get through, and check the ips logs on that firewall. And then set something up to sniff the traffic, in front of the firewall. Check the interface ip mtu, what's it set at?

by jellimonsta

You may want to start out by adjusting the MTU on your router interface, but also (and especially) on your server.

ip tcp adjust-mss 1460 on the router IOS.

You can use Dr. TCP on the server for a GUI to change interface MTU, or you can set it using the below link.

http://www.cisco.com/en/US/tech/tk870/tk877/tk880/technologies_tech_note09186a008011a218.shtml

Jumbo frames could be another potential issue, but I have seen issues in the past with Exchange SMTP over VPN due to MTU.
Good luck.

This discussion is closed to new replies.