Discussion Locked

Local machines don't show up in My Network Places when VPN client connected

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I know it's kind of a long subject line but that is essentially my issue. I have RAS enabled just for VPN with one NIC. Users can connect to the VPN fine and access the network. However, when local users go into My Network Places only the VPN user shows up (when connected). You can search for the machine you want but they should all be listed.

I know this should be a simple fix but I googled it and all I got was how to make the VPN user browse the network....

TYIA,

Eric

3 replies

by Former member

VPN users are "on the other side" with two different subnets, the VPN users need a route to get to the local LAN as well as the local LAN needs a route to get to the VPN users. Also, NetBIOS is a broadcast protocol, in a Windows Network, NetBIOS allows computers to be "seen" in network neighborhood unless you have WINS setup. If WINS is setup then WINS would have to be present on the VPN as well as local LAN.

See this link for some essential info:

http://www.microsoft.com/technet/community/columns/cableguy/cg0101.mspx

More technical info is at:

http://www.howtonetworking.com/Windows/vpnsetup.htm

by eric

kam,

Thanks for the reply. It's the local side that is of concern, not the remote side of the VPN. On the local network, viewing network neighborhood, no machines are visible ONLY when someone is connected to the VPN from outside. How can this be fixed?

This discussion is closed to new replies.