General discussion

Locked

MS DOS Client

By Informatica ·
How can i connect a dos machine to a nt domain?

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Use MS Network Client for DOS

by ngunity In reply to MS DOS Client

To connect your DOS machine to your NT network you need to create a boot disk to setup your networking for you.

How to Set Up the MS Network Client Version 3.0 for MS-DOS -
http://www.microsoft.com/TechNet/msdos/technote/dosnet.asp

How to Provide Additional NDIS2 Drivers for Network Client 3.0
http://support.microsoft.com/support/kb/articles/Q128/8/00.asp

Read the above article and the applicable related ones listed at the bottom to learn how. The instructions are a bit sketchy but you should be able to work through it.

Connecting DOS to your network is a great way to install an OS if you don't have a CD-ROM drive on the client.

good luck

Back to Desktop Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums