Question Locked

MSTSC -The Client could not establish a connection to the remote computer

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Answers Please:
I connect via MSTSC to a 2003 server no problem.
I restart that server and discover that the server has not restarted.
I attempt to connect back to it via MSTSC and get the following message:

The Client could not establish a connection to the remote computer
The Most Like causes for this error are:
1) Remote connections might not be enabled at the remote computer.
2) The maximum number of connections was exceeded at the remote computer.
3) A network error occurred while establishing the connection.

Question: I except that MSTSC has stopped/failed:
How can I kick start server to allow MSTSC access?

NB: I can see that the server is up as I have a RIB card connected.

5 replies

by joshuabj

I found your post a bit late while doing some research about seemingly the same issue. It sounds as if your RDP-tcp client has dropped off and recreating it may solve your problem.

by pharstvedt

I am having the same issue here the last two reboots this week.

I have been rebooting this 2003 server remotely for over a year without issue.

Is this indicating a software/hardware issue?

Thanks

by joshuabj

I would have to be a bit more familiar with you system to make a truly accurate judgement. However, based on what you wrote in your post I am assuming that you recreated the RDP listener and this resolved the issue both times. Under that assumption I wouldn't think this to be a hardware issue since everything works fine after you recreate the listener it would most likely be software with the RDP listener. You may want to check for corruption in the registry on the port number. You can find this at "HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Terminal Server\WinStations\RDP-Tcp". The "PortNumber" subkey should have a value of 00000D3D which is 3389 (the default port used by RDP).

This discussion is closed to new replies.